Light dependent relay AZ-112 230 V

Power supply: 195÷253 V AC
Maximum load: 16 A
Mounting: on 35 mm rail

Twilight switch with Ø10 mm external probe included.

Automatic twilight light switch is used to control light sources or other energy receivers depending on the intensity of the light - it turns off at dawn and turns on at dusk.

Functioning:

The probe of relay should be situated at place with permanent access to day light, which, due to its changes of intensity, will cause switching ON and OFF the lighting. The exact time of swit ching the lighting can be set by potentiometer by the user. Turn in the direction of „half moon” will delay switching-ON, turning in the direction of „sun” will advance switching-ON. The relay is equipped with a delay system, which delays switching ON and OFF the lighting, thus eliminating the influence of accidental di sturbances like thunder lightings on the relay functioning.

Attention!
In case of the length of the cable probe longer than 10m, should not be lead close to parallel power cable.  
 
 

Attention!
In the case of control measures light dependent relay tightly cover the entire appliance, such as a cardboard box or a dark, thick cloth. Cover only the "eye" the probe, such as the finger is not enough, because the intensity of sunlight is very strong and is passes to f by a plastic cover and the human body.

Attention!
There is possibility of a special implementation of automatic voltage other than those indicated in the table of technical data, such as 12V, 24V, 48V and 110V AC / DC and others.